Epson C11C686201 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Multifunkční zařízení Epson C11C686201. Epson C11C686201 User's Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Caution: Do not open ink cartridge packages until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.
If anything is missing, contact Epson
®
as described on the back
in “Any questions?”.
Remove all the tape.
Unpack
1
Start Here
*411016800*
*411016800*
Install ink cartridges
4
Note: Don’t load paper before installing the ink cartridges.
1 Lift up the scanner.
2 Open the cartridge cover.
3 Unpack the ink cartridges.
4 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
3 Close the scanner.
Note: Don’t connect the RX680 Series
to the computer yet.
3 Load paper against the right edge guide and behind the tab, with the
printable side face up.
Note: Don’t load the paper sideways;
always load it short edge first.
4 Slide the edge guide over.
Front paper cassette
1 Pull out the paper cassette.
2 Lift off the cover.
3 Press in the tab on each edge
guide and slide them to fit the
paper you are loading.
4 Load paper with the printable side
face down.
Note: Don’t load paper above the
arrow mark inside the paper guide.
5 Fit the edges of the paper
against the paper guides.
Note: Make sure the paper
fits properly.
6 Replace the cover and insert the cassette back into the printer.
Rear sheet feeder
1 Open the paper support and pull up its extension.
2 Slide the edge guide to the left.
5
Load paper
Paper support
Brighter or
glossier side
down
1 Make sure the scanner
is open.
2 Connect the USB cable (not included) and route it through the slot.
Connect USB cable
2
1 Connect the power cable.
2 Press the On button.
Turn on the RX680 Series
3
5 Insert the cartridges in
the holder for each color.
6 Press the cartridges down until they click.
7 Close the ink cartridge cover and press it
down until it clicks.
8 Close the scanner.
9 Press the OK button to charge ink. Charging takes about 2
1
/2 minutes.
Caution: Don’t turn off the RX680 Series while the On light is
flashing or you’ll waste ink.
8½ x 11 4 x 6 or 5 x 7
8½ x 11 4 x 6 or 5 x 7
Brighter or glossier side up
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Start Here

Caution: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.If anything i

Strany 2

Caution: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.If anything i

Strany 3

Caution: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.If anything i

Strany 4

Caution: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.If anything i

Strany 5 - Open the output tray

4 When you see this screen, click the first option and then click Next, unless the RX680 Series is connected to your computer through an external pri

Strany 6

4 When you see this screen, click the first option and then click Next, unless the RX680 Series is connected to your computer through an external pri

Strany 7

4 When you see this screen, click the first option and then click Next, unless the RX680 Series is connected to your computer through an external pri

Strany 8

4 When you see this screen, click the first option and then click Next, unless the RX680 Series is connected to your computer through an external pri

Komentáře k této Příručce

Žádné komentáře