Epson 20 Uživatelský manuál stáhnout pdf (Strana 44)

Check each list to see if all the information is correct. If any setting is

incorrect, highlight

Change settings

and press

Enter.

The main

Setup menu appears and you can change the setting.

If you did not make any changes or you want to cancel the changes

you made, highlight Exit without saving and press Enter. The

Operation menu appears on the screen. Press 0 and Enter to return

to the MS-DOS command prompt. (If you changed the time or date,

however, the new setting will be in effect.)

If you want to save the settings you made, remove the Reference

diskette and insert the Startup diskette in the drive. Highlight

** EXIT AND SAVE**

and press

Enter.

The program stores the

new settings and resets the computer using the new configuration.

The computer loads MS-DOS and displays the date prompt. Press

Enter

once to accept the displayed date and a second time to accept

the time. The A> prompt appears on the screen.

If the computer displays a setup error message while it is starting up,

run the Setup program again and check all your settings.

2-14

Running

the

Setup Program

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 217 218

Žádné komentáře

Epson 20 Uživatelský manuál Strana 44