Epson EB-G6050W Guide Uživatelská příručka Strana 90

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 123
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 89
Troubleshooting
89
Problem Solving
Reading the Indicators
You can check the status of the projector from the flashing and lit , (operation indicators),
o
and
m
on the control panel.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.
Indicator status during an error/warning
: Lit : Flashing : Status maintained : Off
Indicators Status Remedy
(blue)/(orange)
Replace Lamp
It is time to replace your lamp. Replace the lamp with a new
lamp as soon as possible.
s p.106
The lamp may explode if you continue to use it in this status.
(blue)/(orange)
High Temp Warning
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
If the air filter is clogged, clean it. s p.102
Zobrazit stránku 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 122 123

Komentáře k této Příručce

Žádné komentáře