Epson EB S6 Uživatelská příručka stáhnout pdf (Strana 52)

Problem Solving

f t Power indicator lights red

: Lit : Flashing: : Off

Status Cause Remedy or Status

Internal Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest

address provided in the Support and Service Guide. s Epson Projector Contact List

Fan Error

Sensor Error

Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest

address provided in the Support and Service Guide. s Epson Projector Contact List

Auto Iris error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest

address provided in the Support and Service Guide. s Epson Projector Contact List

High Temp Error

(overheating)

The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector

switches to standby condition, so check the following two points.

• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.

• If the air filter is clogged, clean or replace it. s p.65, 71

If the error continues after checking the points above, stop using the projector, disconnect the power cable from the

electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s Epson

Projector Contact List

When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.45

Problem

Red

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 115 116

Žádné komentáře

Epson EB S6 Uživatelská příručka Strana 52