Epson ES-600C Uživatelská příručka Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 90
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
Terminator setting
If the scanner is the only SCSI device you are going to connect
to your computer or if it is the last device in the daisy chain,
leave the terminator on. The terminator is on when Switch 1 of
the terminator switches, located between the SCSI connector on
the rear panel, is on. See below for the location of the switches.
The scanner should always be the last device on the daisy
chain. You do not need to change the factory settings for the
terminator switches as long as the scanner is the only SCSI
device or the last SCSI device in the daisy chain.
If you decide to connect the scanner in the middle of the daisy
chain, turn terminator Switch 1 off. (Switch 2 must always be
off.)
Connecting the SCSI
connect the scanner with the SCSI as follows:
1.
See that the scanner, the computer, and all other SCSI
devices are turned off and unplugged from the power
source.
Connecting the Scanner to the Computer
2-7
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 89 90

Komentáře k této Příručce

Žádné komentáře