Epson ExpressStation Technické informace stáhnout pdf

EPSON

Product Support Bulletin

Subject: Proper Method for Running Benchmark and Diagnostics Programs

Date: 06/04/93

PSB No: S-0158

Page(s): 1 of 1

Originator: MWT

This bulletin describes the proper method for running any benchmark or diagnostics

programs. This applies to any computer system.

In most cases, the computer should be started using an MS-DOS boot diskette

that’s ‘clean’ -

in other words, one with no CONFIG.SYS or AUTOEXEC.BAT files.

The appropriate executable can then be run, either from diskette or hard drive.

There will be some exceptions to the above rule. In attempting to benchmark or

troubleshoot any add-on that requires a device driver (CD-ROM, local area network,

etc.), obviously the necessary device driver(s) must be loaded. Also, some

programs will require a minimum number of FILES or BUFFERS to be defined in

the CONFIG.SYS file. Such programs will usually display this requirement if they

are run without the necessary CONFIG.SYS file.

For the most consistent results, use the absolute minimal boot configuration that’s

allowed by the hardware being tested.

1 2 3 4 5 6 ... 10 11

Shrnutí obsahu

Strany 1 - Product Support Bulletin

EPSONProduct Support BulletinSubject: Proper Method for Running Benchmark and Diagnostics ProgramsDate: 06/04/93PSB No: S-0158Page(s): 1 of 1Origin

Strany 2

PSB No: S-0147Page: 9 of 9H If you will load your operating system from a NON-SCSI disk drive but willalso access the SCSI devices controlled by the b

Strany 3

PSB No.: S-0062IPage: 1 of 18ACTION DESK 4000VER PART # DESC TYPE LOC REASON4.00 451-7010-201 PHOENIX 27C010 U27 INITIAL RELEASEEQUITY 486SX/25 PLUS

Strany 4

EPSON AMERICA, INC.Product Support BulletinSubject: Epson ExpressStation- Common Questions and AnswersDate: 10/09/92PSB No: S-0147Page(s): 1 of 9Origi

Strany 5

PSB No: S-0147Page: 2 of 9Q4.What levels of security are provided with the Epson ExpressStation?A.There are several levels of security to insure that

Strany 6

PSB No: S-0147Page: 3 of 9Q7.What is the external cache memory option?A.In addition to the i486’s internal cache, the ExpressStation provides asocket

Strany 7 - EISA CONFIGURATION

PSB No: S-0147Page: 4 of 9Page Two- Video CardVGA/EGA, CGA40, CGA80, MONO or not installed- 800 X 600 Mode Refresh Rate56/60 or 72 HZ.-1024 X 768 Mode

Strany 8 - SYSTEM.SCI

PSB No: S-0147Page: 5 of 9- Serial Port Oneenabled/disabled- Serial Port Twoenabled/disabled- Console Redirection to Serial Port 1Disabled1200, 2400,

Strany 9 - MASS STORAGE

PSB No: S-0147Page: 6 of 9- Shadow D0000 to D3FFFenabled/disabled- Shadow D4000 to D7FFFenabled/disabled- Shadow D8000 to DBFFFenabled/disabled- Shado

Strany 10

PSB No: S-0147Page: 7 of 9Q12. Where is the information stored?A.It is saved in the computer’s FLASH memory and a file calledSYSTEM.SCI. Once you conf

Strany 11 - EXPRESS STATION

PSB No: S-0147Page: 8 of 9MEMORYQ14.What is the standard memory configuration and maximum amount ofmemory that can be used in the system?A.The Express