Epson ActionPrinter-2000 Uživatelský manuál Strana 104

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 127
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 103
Initialization
There are two ways that the printer can be initialized (returned to
a fixed set of conditions).
Hardware initialization
• The power is turned on.
• The printer receives an INIT signal from
the parallel interface (pin 31 goes LOW).
Software initialization
• Software sends the ESC @ (Initialize the
printer) command.
Default settings
The table below shows the default conditions that become
effective
when the printer is initialized.
Item
Default condition
Too of form position
Current paper position
Page length
Left and right margins
Line spacing
The current DIP-switch setting
Canceled
1/6 inch
Vertical tab position
Horizontal tab positions
Font selection
Special printing effects
Cleared
Every eight characters
The current SelecType setting
Canceled
Hardware: cleared
Software: deselected only
In addition, hardware initialization clears the data buffer of all
text.
7-10
Technical Specification
Zobrazit stránku 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 126 127

Komentáře k této Příručce

Žádné komentáře