Epson Ap1310-DC Návod k obsluze stáhnout pdf (Strana 17)

WALL AND BELT MOUNTING INSTRUCTIONS

A combined bracket/clip suitable for attaching the printer to a wall or belt is available

The bracket snaps into the bottom of the printer, and when used to clip to a belt, it may be secured by

using the supplied extended screw (replaces the battery compartment screw). Prior to use, two small

'break-outs' must be removed from the battery cover of the printer as shown below:

Remove the two 'break-outs'

usin

a small screwdriver.

When attaching to a belt, the bracket should be put on the printer first, and then the entire assembly

clipped over the belt as shown:

The securing screw may be used if required.

When attaching to a wall, the bracket must be located on the wall using screws and wall plugs as shown.

The printer may then be clipped into place and removed as required.

Use a finger or small screwdriver to

release the clip and then gently lift

the printer to remove from the wall

bracket.

1 2 ... 12 13 14 15 16 17 18 19

Žádné komentáře

Epson Ap1310-DC Návod k obsluze Strana 17