Epson APJ29421 Manuál s instrukcemi

1IMPORTANT If your printer is new, set it up according to the enclosed manufacturers instructions. This is a check to ensure your new printer and dr

10Step 9 Installing the Chip Block Unit You are now in a position to remove the Epson cartridges from the printer head, see Fig.20 & Fig.21 belo

11Step 10 Installing the Chip Support Bars When you have positioned the chip blocks into place you will need to insert and install the support bars

12Step 11 Install Injectors Please place the set of 6 injectors in the printer carriage that is now parked in the centre of the printer. Carefully

13Align and locate the SLOT in the R1400 printer head as indicated in Fig.32. When you have installed the special printer lid on the R1400 it should

14Step 14 Installing the Central Tube Support Bracket & Aligning the Tubes The Tube Support Bracket has Self Adhesive Strips on it. Use an alcoh

15Please ensure that the tubing has just enough slack which may need to be adjusted to allow movement of the print head without restriction. This can

16When you have carefully installed and aligned the tube clip in its correct location, press firmly ensuring that the tube clip is clicked and stuck

17 43mm Position the Foam Strip in its correct location as When you have placed the right hand side of indicated

18Step 17 Testing the System Push the injectors to the far right and plug the printer back on. Have your graphics program (e.g. Photoshop) open and

19 Step 18 Removing the Injectors Please note before removing the injectors you MUST clamp the tubing on the relevant injectors by LOCKING the Whi

2 Check List for Components _________________________________________________________________

20 ON THE COMPACT DISC :- THERE IS A CD SUPPLIED WITH YOUR KIT. ON THE CD ARE COPIES OF THE FOLLOWING :- 1 ECO-FLO INSTALLATION INSTRUCTIONS FOR

21 FAQ»S & Caring For Your Eco-Flo √ READ CAREFULLY!!! Here are some tips to make sure that your new system performs trouble-free. • It is ad

3 Check Printer Condition If you have a brand new printer, follow the Epson instructions for setting up your printer. Use the Epson cartridges that

4INSTALLATION OF YOUR ECO-FLO KIT Step 1 Removing the Injector Lid You will need to remove the printer lid on the injector carrier as shown illustr

5Step 2 Moving the Printer Head You are now able to move the printer head manually to the centre area of the printer. See below.

6Step 4 Tube Preparation Using a pair of scissors snip gently at the end of each tube. Please see Fig.8 below. Strip back

7Step 5 Preparation of The Clamps & Inks You are now ready to attach the tube clamps to the tubes as indicated in Fig.11 below. Now please fil

8Step 7 Assembling the Tubing to the Bottle Caps When you have completed the above process insert the correct tubes to the correct ink bottles. PLE

9PLEASE ENSURE THAT THE WING ADAPTOR (TIP ONLY) IS GENTLY, BUT MAKES A FIRM SEAL ON THE BASE OF THE INJECTOR, DO NOT push the tip into the injector a