Epson Stylus Color II Ink Jet Printer Průvodce řešením problémů stáhnout pdf (Strana 9)

The paper thickness lever on the right side of the sheet feeder

has two settings: plain paper and thick paper. Set the lever to

the position that best suits the paper or other media you plan

to use, as shown in the following table and illustration.

Paper type Paper thickness lever position

Standard paper Plain paper

Transparency film Plain paper

Envelopes Thick paper

Use the table below to set the thickness adjustment lever for

your media type.

Paper type

Thickness adjustment lever

position

Standard paper 0

Transparency film 0

Envelopes +

Previously smeared documents +

If a document is smeared, set the thickness adjustment lever

to the + position (regardless of the paper type) and print it

again.

To access the lever, open the printer cover; the lever is in the

left back corner, as shown in the following illustration.

When using special coated paper, glossy paper,

transparencies, or envelopes, keep the following in mind:

❏

Use special coated paper and glossy paper within one

year of purchase. Use transparencies within six months.

❏

Do not touch the printable surface of the paper; hold the

sheets by their edges. The moisture and oils on your

hands can reduce print quality.

❏

After printing on high-quality glossy paper or

transparencies, remove each sheet from the output tray

immediately. Make sure each sheet is dry before stacking.

❏

Return unused sheets and envelopes to their original

package as soon as possible after you finish printing.

Unfavorable storage conditions—especially high

temperature, humidity, and direct sunlight—can damage

the media.

❏

Follow any other special loading procedures included in

the rest of this section.

Loading Special Papers and Transparencies

You can load up to the following number of sheets in the

sheet feeder:

❏

70 sheets of special coated paper

Note:

If you load legal-size special coated paper for 720 dpi, do not load it

more than halfway to the arrow on the left edge guide.

❏

50 sheets of transparency film with one sheet of plain

paper beneath the last transparency in the stack

❏

30 sheets of high-quality glossy paper with a sheet of

plain paper beneath the last sheet in the stack.

Note:

To avoid printing on the plain paper, print one page at a time.

Follow these steps to load special paper or transparency film:

1. Lower the output tray at the front of the printer and slide

out the extension.

2. Slide the left edge guide on the sheet feeder to the left as far

as it will go.

3. Prepare the paper or transparency film as described above.

4. If you are loading a stack of paper or transparencies, fan

the stack and then tap it on a flat surface to even the edges.

EPSON Stylus COLOR II

Ink Jet Printers 8/1/95 EPSON Stylus COLOR II-9

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Epson Stylus Color II Ink Jet Printer Průvodce řešením problémů Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Tisk a skenování Epson Stylus Color II Ink Jet Printer