Epson PixiePlus Control System for Projectors Instalační manuál stáhnout pdf

PixiePlus

ELPSP10 Supplement

for the Epson

Projector Controller

Contents

1. Installation of the Epson Projector Controller with the Epson AP-60

Configuration 1 – Projector Volume Control

Configuration 2 – AP-60 IR Volume Control

2. Using the Programming Wand (PXE-PGM-TOOL) to Reprogram the PixiePlus

3. Using the Programming Wand to Set Schedule Events

4. Restoring the PixiePlus to its Default Preconfiguration

1. Installation of the Epson Projector Controller with the Epson AP-60

The PixiePlus may be easily set up to work with the Epson AP-60 Audio System in two

basic configurations.

Configuration 1 – Projector Volume Control

In this configuration, route the

audio for the various display

devices in your room through your

Epson projector. The PixiePlus will

control the audio switching and

volume level on the projector with

its preconfigured RS-232 codes.

Connect the audio output from the

projector to the audio input on the

AP-60.

A. Connect the audio outputs from

your display devices to your

projector as shown in the projector

documentation.

B. Connect the 3.5mm jack labeled

Audio Out on your projector to the

AP-60 jack labeled Line 1 LCP.

Once this cable is connected the projector speakers will be inactive.

C. If you wish to control the power On/Off of the AP-60 connect the IR emitter output

from PixiePlus Ceiling Plate to the IR receiver of AP-60 to enable power control of AP-60

when the PixiePlus Audio button is pressed. The IR codes for AP-60 are preconfigured

in the PixiePlus.

1 2 3 4 5

PixiePlus 1
ELPSP10 Supplement 1

Shrnutí obsahu

Strany 1 - ELPSP10 Supplement

PixiePlusTM ELPSP10 Supplementfor the Epson® Projector ControllerContents1. Installation of the Epson Projector Controller with the Epson AP-60Confi

Strany 2

Configuration 2 – AP-60 IR Volume Control In this configuration the PixiePlus will control the volume level of the AP-60 directly withIR codes. If you

Strany 3

2. Using the Programming Wand (PXE-PGM-TOOL) to Reprogram thePixiePlusThe Programming Wand (PXE-PGM-TOOL, not included) may be used to reprogram thePi

Strany 4

G. Program PixiePlus: Place the wand so that it is linedup against the top of the PixiePlus bezel as shown. Besure the plastic window of the Wand whic

Strany 5

A. Connect the Programming Wand to your PC and launch the Configuration Utility asdescribed in section 2, steps A-B above. B. Select the Wand Time tab

Komentáře k této Příručce

Žádné komentáře

Epson PixiePlus Control System for Projectors Instalační manuál

Procházejte online nebo si stáhněte Instalační manuál pro Dálková ovládání Epson PixiePlus Control System for Projectors. Epson PixiePlus Control System for Projectors Installation Supplement Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání Epson PixiePlus Control System for Projectors