Epson Personal Document Station Mac Technické informace

Printed on recycled paper with at least 10% post-consumer content.

8. Click Install into Hard disk. Follow the prompts on the screento complete the installation and restart your Macintosh.(Once installed, e•Paper will

3. Flip down the two paper guides to the operating position, asshown below.4. Fan the edges of your document if you are scanning multiplepages; then l

6. Adjust the paper guides to fit the width of the paper. The scanner automatically feeds the first page of yourdocument to the scanning position. Not

Note:After cropping an image, the new settings are used to scan theremaining pages of your document. You may need to reset thecropping area before sca

Where to Get Help EPSON provides customer support and service through anetwork of Authorized EPSON Customer Care Centers andprovides the following ser

World Wide WebIf you are connected to the Internet and have a Web browser,you can access EPSON’s World Wide Web site athttp://www.epson.com. EPSON’s

EPSON Forum on CompuServe®CompuServe members can access the Epson America Forumon CompuServe. If you are already a member, simply type GOEPSON at the

A Note Concerning Responsible Use of Copyrighted MaterialsLike photocopiers, scanners can be misused by impropercopying of copyrighted material. Altho

Introduction This package contains everything you need for professionalquality document scanning and processing: ❑ EPSON® Personal Document Station (E

This booklet tells you how to set up your scanner, install thesoftware, and scan a document. For additional instructions, seethe manual for the ES-300

Setting Up the Scanner Follow the steps below to set up the scanner and connect it tothe SCSI port on your Macintosh or to another SCSI device.The SCS

5. The scanner’s SCSI terminator is set to ON at the factory. If the scanner is the only or last device in the SCSIdaisy-chain, leave the terminator a

7. If you are connecting the scanner directly to your Macintosh,connect the 25-pin connector on the dual-connector end ofthe cable to the SCSI port on

8. Connect the scanner’s power cable to the power inlet on therear of the scanner and plug the other end into a groundedelectrical outlet.9. Raise the

11. Turn on any other external devices you will use before youturn on the Macintosh. (Always turn on the scanner beforeturning on the computer.)The sc