Epson PowerLite 5000 Servisní příručka Strana 100
- Strana / 127
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
EPSON PowerLite 5000 Service Manual
4-5
Disconnect all interface cables and the projector lens cover.
Then connect the power cable.
B
Do the operation and lamp
indicators display the first 3
conditions described in the
table on the next page?
Does the exhaust fan work?
Refer to the table on next
page according to the lamp
indication.
Now does the exhaust fan
work?
Replace the main board.
Replace the exhaust fan.
Press the Power button on the control
panel. Does the operation or lamp
indicator light up or blink?
Make sure CN600 is
connected. Then replace
the control panel.
Press the Power button on the control
panel. Does the operation or lamp
indicator light up or blink?
Press the Power button on the control
panel. Does the operation or lamp
indicator light up or blink?
Replace the power supply
unit.
Is the lamp cover secured to
the lower case?
Install the lamp cover and
lamp inner housing again.
Replace the safety switch.
Is the safety switch
resistance almost 0 ohms?
• Disconnect the power
cable.
• Disconnect the
Fast-on tab from the
safety switch.
• Measure the safety
switch resistance.
A
B
Go to Start
Go to Display/
Picture.
AC Measurement Point
Caution:
Measure the resistance when the safety
switch has cooled down.
YES
YES
NO
YES
NO
YES
NO
YES
YES
NO
Press the power button on
the remote control.
Does the operation or lamp
indicator light up or blink?
Power ON/OFF
Start
Press the power button on
the control panel.
Now does the operation or
lamp indicator light up or
blink?
Is AC power applied to
the power supply unit
connector?
NO
NO
YES
YES
NO
NO
YES
NO
NO
YES
NO
YES
Figure 4-4
- Service Manual 1
- PowerLite 5000 2
- VCCI COMPLIANCE STATEMENT 3
- REVISIONS 3
- COPYRIGHT INFORMATION 3
- TRADEMARK INFORMATION 3
- INTRODUCTION 4
- PRECAUTIONS 5
- Contents 7
- CHAPTER 4 TROUBLESHOOTING 9
- APPENDIX A 9
- 1.1 PRODUCT FEATURES 10
- 1.2 PARTS OF THE PROJECTOR 11
- Figure 1-3 12
- Figure 1-4 12
- Figure 1-5 13
- Figure 1-6 13
- Figure 1-8 14
- Figure 1-9 15
- 1.3 CONNECTIONS 16
- Power Book 18
- Table 1-1 18
- Video Devices 19
- Audio Devices 19
- 1.4 MAIN COMPONENTS 20
- FR board 21
- CN board 21
- Receptor boards 21
- Speakers 22
- Inlet unit 22
- Filter unit 22
- Power supply unit 23
- Lamp inner housing 23
- Control panel 23
- Optical engine 24
- Top side view 24
- Bottom side view 24
- 1.5 SPECIFICATIONS 25
- POWER SUPPLY 26
- 1.6 INTERFACE SPECIFICATIONS 27
- 1.6.5 S-Video 28
- 1.6.6 Video-In 29
- 1.6.7 Audio In L/R 29
- 1.6.8 Mouse / Com 1/2 30
- 2.1 HARDWARE 31
- Figure 2-2 33
- FC board 34
- Figure 2-3 34
- Figure 2-4 35
- 2.2 POWER SUPPLY UNIT 36
- Functional Outline 37
- Figure 2-7 38
- 2.3 MAIN BOARD 39
- • Lamp power 40
- • Backup Power 40
- 2.4 DRIVER BOARD 42
- Figure 2-11 44
- 2.5 CONTROL PANEL 45
- 2.6 AU BOARD 46
- 2.7 FR BOARD 48
- Figure 2-16 49
- 2.8 CN BOARD 50
- Figure 2-19 51
- Figure 2-20 51
- Figure 2-21 52
- 2.10 SPEAKER UNIT 53
- 2.11 LIGHT GUIDE BLOCK 54
- • Lens Arrays A and B 55
- 2.12 LAMP INNER HOUSING 56
- Light source lamp 57
- Fuse board (FU board) 58
- 2.13 SENSORS/SWITCHES 59
- 2.13.1 Filter Cover Switch 60
- 2.13.2 Interlock Switch 61
- 2.13.3 Safety Switch 61
- 2.13.5 LV Thermistor 62
- 2.13.4 Lamp Thermistor 62
- 2.13.6 PBS Thermistor 63
- 2.14 BOARD CONNECTIONS 64
- Figure 2-37 65
- Figure 2-38 65
- AC InIet 66
- Power Supply Connector 66
- Connector Board 66
- 3.1.1 Preparatory Procedures 67
- 3.1.4 Mechanical Adjustments 68
- Driver Board 69
- 3.1.6 Precautions 70
- Figure 3-1 71
- Figure 3-2 72
- Figure 3-3 72
- Figure 3-4 73
- Figure 3-5 74
- Figure 3-6 74
- Figure 3-7 75
- Figure 3-8 75
- Figure 3-9 76
- Figure 3-10 76
- Figure 3-11 77
- Figure 3-12 77
- Figure 3-13 78
- Figure 3-14 78
- Caution: 79
- 3.2.8 Removing the Main Board 80
- Figure 3-18 81
- 3.2.9 Removing the AU Board 82
- Figure 3-20 83
- Figure 3-21 84
- 3.2.11 Removing the FR Board 85
- Figure 3-24 86
- Figure 3-25 86
- Figure 3-26 87
- Figure 3-27 88
- Figure 3-28 88
- Figure 3-29 89
- Figure 3-30 90
- Figure 3-31 90
- Figure 3-32 91
- Figure 3-33 92
- Figure 3-34 92
- 3.2.20 Removing the CN Board 93
- Figure 3-37 94
- 3.2.22 Removing the FC Board 95
- Figure 4-1 97
- Figure 4-2 98
- Figure 4-3 99
- Power ON/OFF 100
- Continued from page 4-5 101
- Go to start 101
- Display/Picture 102
- Figure 4-7 103
- Audio Output 104
- Control Panel 105
- Remote Control 106
- Mouse/COM 107
- Figure 4-12 108
- A.1 Parts List 109
- A.2 Exploded Diagrams 112
- Figure A-2 113
- Figure A-3 114
- Figure A-4 115
- Figure A-5 116
- Figure A-6 117
- Figure A-7 118
- Figure A-8 119
- Figure A-10 120
- Figure A-11 121
- Figure A-12 122
- Figure A-13 123
- Figure A-14 124
- Figure A-15 126
- Figure A-16 127
Související produkty a manuály pro Bridge kamery Epson PowerLite 5000
Bridge kamery Epson PhotoPC700 Uživatelská příručka
(57 stránky)
(57 stránky)
Bridge kamery Epson PhotoPC 750Z Specifikace
(10 stránky)
(10 stránky)
Bridge kamery Epson PhotoPC Uživatelská příručka
(140 stránky)
(140 stránky)
Bridge kamery Epson PhotoPC 550 Specifikace
(12 stránky)
(12 stránky)
Bridge kamery Epson PhotoPC L-400 Uživatelský manuál
(65 stránky)
Bridge kamery Epson PhotoPC 800 Specifikace
(14 stránky)
(14 stránky)
Bridge kamery Epson A882401 Specifikace
(8 stránky)
(8 stránky)
Bridge kamery Epson ELPD04 Uživatelský manuál
(2 stránky)
(2 stránky)
Bridge kamery Epson PhotoPC 3000Z Uživatelská příručka
(224 stránky)
(224 stránky)
Bridge kamery Epson A882401 Technické informace
(144 stránky)
(144 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.063 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce