Epson PowerLite 5000 Servisní příručka Strana 57
- Strana / 127
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
EPSON PowerLite 5000 Service Manual
2-27
Light source lamp
The standard lamp life is 2000 hours. If you notice reduced lamp brightness, replace the
lamp inner housing even if you have used the projector for less than 2000 hours.
The total running time of the light source lamp is written in the EEPROM (IC603:
ST24W04FM6TR) on the main board. If the lamp is nearing or has reached the end of its
life, IC600 (M37732S4BFP) outputs signals to control the following:
When the total running time has reached 1900 hours (1900~2000), the orange and red
lamp indicators blink alternately. The controller (IC600) on the main board counts the total
running hours and writes the data in IC603. The lamp runs only 100 hours after the orange
and the red lamp indicators start to blink alternately, so you should replace the lamp as
soon as possible. (If the lamp indicators blink alternately when you turn the projector on,
the lamp life is no more than 100 hours. Therefore, the lamp life may be suddenly
terminated.)
When the total running time has reached 2000 hours, the fuse in the lamp inner housing is
blown by the LFUSE signal from IC600 and the lamp is turned off, then the cooling down
operation starts (the orange lamp indicator blinks). Afterward, the lamp will not run until
you replace it with a new one.
- Service Manual 1
- PowerLite 5000 2
- VCCI COMPLIANCE STATEMENT 3
- REVISIONS 3
- COPYRIGHT INFORMATION 3
- TRADEMARK INFORMATION 3
- INTRODUCTION 4
- PRECAUTIONS 5
- Contents 7
- CHAPTER 4 TROUBLESHOOTING 9
- APPENDIX A 9
- 1.1 PRODUCT FEATURES 10
- 1.2 PARTS OF THE PROJECTOR 11
- Figure 1-3 12
- Figure 1-4 12
- Figure 1-5 13
- Figure 1-6 13
- Figure 1-8 14
- Figure 1-9 15
- 1.3 CONNECTIONS 16
- Power Book 18
- Table 1-1 18
- Video Devices 19
- Audio Devices 19
- 1.4 MAIN COMPONENTS 20
- FR board 21
- CN board 21
- Receptor boards 21
- Speakers 22
- Inlet unit 22
- Filter unit 22
- Power supply unit 23
- Lamp inner housing 23
- Control panel 23
- Optical engine 24
- Top side view 24
- Bottom side view 24
- 1.5 SPECIFICATIONS 25
- POWER SUPPLY 26
- 1.6 INTERFACE SPECIFICATIONS 27
- 1.6.5 S-Video 28
- 1.6.6 Video-In 29
- 1.6.7 Audio In L/R 29
- 1.6.8 Mouse / Com 1/2 30
- 2.1 HARDWARE 31
- Figure 2-2 33
- FC board 34
- Figure 2-3 34
- Figure 2-4 35
- 2.2 POWER SUPPLY UNIT 36
- Functional Outline 37
- Figure 2-7 38
- 2.3 MAIN BOARD 39
- • Lamp power 40
- • Backup Power 40
- 2.4 DRIVER BOARD 42
- Figure 2-11 44
- 2.5 CONTROL PANEL 45
- 2.6 AU BOARD 46
- 2.7 FR BOARD 48
- Figure 2-16 49
- 2.8 CN BOARD 50
- Figure 2-19 51
- Figure 2-20 51
- Figure 2-21 52
- 2.10 SPEAKER UNIT 53
- 2.11 LIGHT GUIDE BLOCK 54
- • Lens Arrays A and B 55
- 2.12 LAMP INNER HOUSING 56
- Light source lamp 57
- Fuse board (FU board) 58
- 2.13 SENSORS/SWITCHES 59
- 2.13.1 Filter Cover Switch 60
- 2.13.2 Interlock Switch 61
- 2.13.3 Safety Switch 61
- 2.13.5 LV Thermistor 62
- 2.13.4 Lamp Thermistor 62
- 2.13.6 PBS Thermistor 63
- 2.14 BOARD CONNECTIONS 64
- Figure 2-37 65
- Figure 2-38 65
- AC InIet 66
- Power Supply Connector 66
- Connector Board 66
- 3.1.1 Preparatory Procedures 67
- 3.1.4 Mechanical Adjustments 68
- Driver Board 69
- 3.1.6 Precautions 70
- Figure 3-1 71
- Figure 3-2 72
- Figure 3-3 72
- Figure 3-4 73
- Figure 3-5 74
- Figure 3-6 74
- Figure 3-7 75
- Figure 3-8 75
- Figure 3-9 76
- Figure 3-10 76
- Figure 3-11 77
- Figure 3-12 77
- Figure 3-13 78
- Figure 3-14 78
- Caution: 79
- 3.2.8 Removing the Main Board 80
- Figure 3-18 81
- 3.2.9 Removing the AU Board 82
- Figure 3-20 83
- Figure 3-21 84
- 3.2.11 Removing the FR Board 85
- Figure 3-24 86
- Figure 3-25 86
- Figure 3-26 87
- Figure 3-27 88
- Figure 3-28 88
- Figure 3-29 89
- Figure 3-30 90
- Figure 3-31 90
- Figure 3-32 91
- Figure 3-33 92
- Figure 3-34 92
- 3.2.20 Removing the CN Board 93
- Figure 3-37 94
- 3.2.22 Removing the FC Board 95
- Figure 4-1 97
- Figure 4-2 98
- Figure 4-3 99
- Power ON/OFF 100
- Continued from page 4-5 101
- Go to start 101
- Display/Picture 102
- Figure 4-7 103
- Audio Output 104
- Control Panel 105
- Remote Control 106
- Mouse/COM 107
- Figure 4-12 108
- A.1 Parts List 109
- A.2 Exploded Diagrams 112
- Figure A-2 113
- Figure A-3 114
- Figure A-4 115
- Figure A-5 116
- Figure A-6 117
- Figure A-7 118
- Figure A-8 119
- Figure A-10 120
- Figure A-11 121
- Figure A-12 122
- Figure A-13 123
- Figure A-14 124
- Figure A-15 126
- Figure A-16 127
Související produkty a manuály pro Bridge kamery Epson PowerLite 5000
Bridge kamery Epson PhotoPC700 Uživatelská příručka
(57 stránky)
(57 stránky)
Bridge kamery Epson PhotoPC 750Z Specifikace
(10 stránky)
(10 stránky)
Bridge kamery Epson PhotoPC Uživatelská příručka
(140 stránky)
(140 stránky)
Bridge kamery Epson PhotoPC 550 Specifikace
(12 stránky)
(12 stránky)
Bridge kamery Epson PhotoPC L-400 Uživatelský manuál
(65 stránky)
Bridge kamery Epson PhotoPC 800 Specifikace
(14 stránky)
(14 stránky)
Bridge kamery Epson A882401 Specifikace
(8 stránky)
(8 stránky)
Bridge kamery Epson ELPD04 Uživatelský manuál
(2 stránky)
(2 stránky)
Bridge kamery Epson PhotoPC 3000Z Uživatelská příručka
(224 stránky)
(224 stránky)
Bridge kamery Epson A882401 Technické informace
(144 stránky)
(144 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.193 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce