Epson 2000 Uživatelský manuál stáhnout pdf (Strana 59)

Position one of the memory chips over the socket as shown

below, aligning the pins on the chip with the holes in the

socket. Make sure the small notch on the end of the chip

aligns with the corresponding notch in the socket.

notch

Gently press the chip halfway into the socket (to make sure

it is correctly aligned). If the chip does not go in smoothly,

remove it and try again.

When the chip is properly positioned, push down firmly on

both ends to make sure it is well-seated.

Repeat steps 4 through 6 for each of the remaining chips.

Replace any option cards you removed. See page 3-13 for

instructions.

3-18

Installing and Removing Options

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 128 129

Žádné komentáře

Epson 2000 Uživatelský manuál Strana 59