Epson Equity 286 PLUS Uživatelská příručka stáhnout pdf (Strana 56)

EQRAMDVR.SYS OPTIONS AND OPERATION

There is one option for EQRAMDVR.SYS.

Typing a /n (where n is a

number from 1 to 4) after DEVICE=EQRAMDVR.SYS sets the number of

RAM disks that can be supported.

In the instructions above, the

/2 will allow the Equity I to support two RAM disks.

If the /n

option is omitted,-

EQRAMDVR.SYS sets up support for one RAM disk.

When the system boots,

EQRAMDVR.SYS will display a sign on

message similar to this:

RAM disk emulator support installed at drive(s)-C:, D:

There will from one to four drive letters shown, depending on the

/n option. When you execute your RAM disk program, be sure to

use the drive letter shown in the sign on message. For example,

using Tecmar's MEMDISK program,

you would type this command at

the MS-DOS prompt:

MEMDISK D: -BUF160

This would set up a 160K RAM disk at drive D:.

If you attempt to use one of the EQRAMDVR.SYS drives before

running your RAM disk program, you will get one of the following

error messages:

Not ready error reading drive x

Abort, Retry, Ignore?

Bad command error reading drive x

Abort, Retry, Ignore?

The x would actually be the letter of the drive you tried to

access. Press A to abort,

then run your RAM disk program.

Page 7 of 9

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Žádné komentáře

Epson Equity 286 PLUS Uživatelská příručka Strana 56