Epson Equity 286 PLUS Uživatelská příručka stáhnout pdf (Strana 67)

The NCL

format is

somewhat more complicated. It will ask you

for drive number (0), number of

cylinders (615), number of

heads (4),

reduced write current (615), write precompensation

(615) and

maximum ECC data

error burst

length (11). The

numbers

given here in

parentheses would be typical for the

HMD-720-802. It will then ask if

all is correct; if

yes, it

proceeds with the format. If not,

it returns you to the top of

the input menu. In any case, when it completes the

format, it

may ask

you if

you wish to enter alternate track selections.

Tell it "no".

Invoke the program HDFMTALL. This

program will allow you to

reconstruct the bad track

table, which we just knocked out

with the physical format. HDFMTALL will

ask if

you

want a

"standard" format; press "N".

It will then ask if you want the

default interleave of 3;

you can

accept this

or change it.

(I've found that an interleave of 6 seems to be pretty optimal

on the I and

II.) HDFMTALL will then display the bad track

table and give you

the chance

to edit it. If any bad tracks

are displayed, make sure that any bad locations from the error

list you took off of the drive are indeed flagged. If not,

enter them manually. If the scan turned up

an excessive (more

than 50) number of bad tracks, you might want to delete them

and then manually enter the ones from the

error list. Press

"F" when you are finished and HDFMTALL will proceed with the

warnings and then the actual format.

6. You're now ready to use

HDPART. This program

sets up the

MS-DOS partition

and

writes the DOS file structure to the

disk. Typically' you'll use the entire disk for

DOS,

so that

simplifies matters. Just make sure that the DOS partition is

specified as BOOTABLE. When

you

exit HDPART, the system

automatically re-boots.

The final

step - HDFORMAT. From the A prompt, enter the

following:

HDFORMAT C:

/s/v.

The /S switch transfers the

operating system to the hard drive.

The /V switch causes

HDFORMAT to prompt you for a volume name for drive C. HDFORMAT

now performs the logical format. When finished' remove the

floppy from

drive A and press CTRL-ALT-DEL. The system should

boot from the C drive.

For those of you familiar with the IBM world, the DEBUG format

is the

same.

HDFMTALL

is the equivalent to IBM's Diagnostics

level format;

HDPART is our version of FDISK, and HDFORMAT is

the same as IBM's FORMAT.

Page 2 of 2

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

Komentáře k této Příručce

Žádné komentáře

Epson Equity 286 PLUS Uživatelská příručka Strana 67

Komentáře k této Příručce

Související produkty a manuály pro Barebones pro PC / pracovní stanice Epson Equity 286 PLUS