Epson LQ 670 - B/W Dot-matrix Printer Provozní pokyny stáhnout pdf (Strana 60)

For instructions on how to activate the auto tear-off function, see

“Using the Default-Setting Mode” in Chapter 4 or open the

EPSON Remote! utility as described in Chapter 2 and follow the

on-screen instructions. While using the default-setting mode or

the utility, also make sure the page length is set correctly for your

continuous paper. If you make these settings in the default-setting

mode, be sure to turn off the printer then turn it on again to apply

your settings.

The steps below describe how to use auto tear-off.

1. When you finish printing on continuous paper, the printer

advances the perforation of the final printed page to the

tear-off position.

2. Tear off all printed pages. (If the perforation is not aligned with

the tear-off edge, you can adjust the tear-off position using the

micro-adjust feature. See “Adjusting the tear-off position”

later in this chapter.)

3. When you resume printing, the printer automatically feeds the

paper back to the top-of-form position and begins printing.

(You can also manually feed the paper back to the top-of-form

position by pressing the

Tear Off/Bin

button.)

You can leave auto tear-off mode on even when you are using

single sheets because the mode is disabled when you move the

paper release lever to the single-sheet position.

Adonis Rev.C

A5 size Chapter 3

96/ 12/ 19 pass 5

Paper Handling

3-19

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 187 188

Žádné komentáře

Epson LQ 670 - B/W Dot-matrix Printer Provozní pokyny Strana 60