Epson C82363 Specifikace stáhnout pdf (Strana 37)

Setting the IP Address 3-9

3. If the card is reachable, you see results like the following (the

exact form of the message depends on your operating system,

and the times may vary):

Reply from 11.22.33.44: bytes=32 time=19ms TTL=32

Reply from 11.22.33.44: bytes=32 time<10ms TTL=32

If you can’t ping the Ethernet card, make sure:

❑ The address is correct in the ping command.

❑ The Ethernet card is operating normally (red LED off, green

LED on).

❑ The Ethernet connection to the card and to the host has

been made correctly, and all hubs, routers, etc. are switched

on. If you are using 10Base-2, make sure that both ends of

the segment are terminated.

Setting and checking the new IP address

To set the new IP address, use the address resolution protocol (arp).

Note:

In the following example, the MAC address of the Ethernet card is

00:00:48:93:00:00 (hexadecimal), and the IP address you will assign is

192.135.223.6 (decimal). Substitute your values for these addresses when

you type in the commands.

Chap3.fm Page 9 Friday, August 21, 1998 11:11 AM

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 198 199

Žádné komentáře

Epson C82363 Specifikace Strana 37